can't calibrate the ws-1 unit

Your highest shooting achievement
000
Skill Level
Beginner
Primary Discipline
Air Pistol
SCATT Experience
Less than 1 year
Joined
Aug 27, 2021
3 Posts
0 Helpful Votes
0 Best Q&A Answers
got a ws-1 unit which is detected and works if i point sensor from close range
like 1-2 m - it is clearly detecting the sensor.
but moving back just a little I get sensor absolutely blind.
no matter the angles or location - i just scanned all possible positions - at about 3m it's dead.
moving back to 1-1.5m makes it see the target.

In calibration dialog only first parameter - trigger sensitivity is svailable for adjustments. but other two parameters wich are related to IR and Light brightness are fixed and there is no way to move them.

when I first turned the program on after first installation both these parameters were adjustable.
now they are fixed and I think it's causing the unability to work from longer distances as it's fixed at 0.


I use latest software and firmware update checked and says it's latest - usbdiag shows the target controller and target.
what could be the reason of such issues?
 
OP
T
Your highest shooting achievement
000
Skill Level
Beginner
Primary Discipline
Air Pistol
SCATT Experience
Less than 1 year
Joined
Aug 27, 2021
3 Posts
0 Helpful Votes
0 Best Q&A Answers
The issue was in the wireless sensor. It was repaired and calibrated.

I sent the whole kit to the SCATT factory in Russia. It took about 6 days (3+3) for a shipping round trip and about 1 hour to diagnose and repair. 2 year warranty rules!

Now Starting my training routines.
 
Top